Preparation work before using a small portable oil filter
1. Placing the machine: Place the small handheld oil filter on a relatively flat ground or in the car compartment to ensure that the machine is stable and does not shake. Meanwhile, carefully inspect the entire machine for any looseness, paying special attention to the connection between the motor and oil pump, which must be tightened and concentric.
2. Check the power supply: Before use, ensure that the power supply is connected correctly and the voltage is stable. For three-phase four wire AC power (such as 380V), it is necessary to correctly connect it to the wiring terminals of the oil filter.
3. Check the direction of the oil pump: Before starting the oil pump, observe whether its rotation direction is correct. If the rotation direction is incorrect, it can cause the oil pump to malfunction or suck in air. At this time, the power supply phase sequence should be changed.
When connecting a small handheld oil filter, connect the oil pipe
Connect the inlet and outlet pipes: Connect the inlet pipes to the oil container to be processed, ensuring that the inlet port points towards the oil. At the same time, connect the oil outlet pipe to the container where the processed oil is stored, and ensure that all connections are securely fastened without oil leakage. Note that the oil outlet and oil outlet must be tightened to avoid flushing the oil outlet when the pressure increases.
Small handheld oil filter start-up machine
Start motor: After confirming the above steps are correct, start the motor button and the oil pump will start working normally. At this point, the oil enters the filter under the action of the oil pump, and the oil that comes out after three stages of filtration is called purified oil.
Operation and Maintenance of Small Handheld Oil Filter
Observation of operation: During the operation of the machine, attention should be paid to the operation of the oil pump and motor. If there are any abnormal situations (such as increased noise, abnormal pressure, etc.), the machine should be stopped for inspection and maintenance in a timely manner; Regular cleaning of the filter element: Due to the accumulation of impurities during the filtration process, it is necessary to regularly clean the filter element to ensure the filtration effect. When significant differences are found between the inlet and outlet ports, the filter element should be checked and cleaned in a timely manner; Avoid prolonged idling: When one barrel (box) of oil needs to be pumped out and another barrel (box) needs to be pumped out, it is necessary to act quickly to avoid the oil pump from idling for a long time. If there is no time to replace the oil drum, the machine should be shut down and restarted after the oil inlet pipe is connected.
Shutdown and Storage of Small Handheld Oil Filter
1. Shutdown in sequence: After the oil filter is used, it should be shut down in sequence. Firstly, remove the oil suction pipe and drain the oil completely; Then press the stop button to stop the motor; Finally, close the inlet and outlet valves and roll up the inlet and outlet pipes to wipe them clean for future use.
2. Storage machine: Wipe the machine clean and store it properly in a dry and ventilated place to avoid moisture or damage.